EVA hot melt adhesive 284.00

Application:

For automatic edgebanders, e.g. for edges made of HPL, CPL, polyester,
resinated paper, solid wood and veneer. The special properties of the
edgebands and the reverse primer application have to be tested before use
(especially if thermoplastic edgebands are to be bonded).
Can be used for straight edges, softforming and precoating.

Long open time, high hot tack, good adhesion, good heat resistance;
excellent resistance to oxidation and colour stability in the melt.
Very good mechanical processing characteristics with accurate hot melt
application without stringing.

May be processed on automatic units with roller.
Processing temperature [°C]: 190 – 210
Feed speed [m/min.]: 18 – 60

The properties of the substrates and the processing conditions will influence
the processes of joining and bonding. Customer trials before use are
recommended.

The materials to be used must be free of grease and dust and be dry, they
also have to match perfectly. Wood moisture content should be at 8 – 10 %.
Minimum temperature of substrates and ambient air should not be below
18 °C. Avoid draught.

final digit 0 = beige
final digit 1 = white
final digit 2 = brown

Preliminary cleaning while hot by scraping with a spatula. Remove any
residues when cold with Jowat® Cleaner 402.40.

May be stored for 12 months after date of delivery ex production site, cool
and dry.

For further information concerning handling, transport and disposal, please
refer to the Safety Data Sheet.
Our information on this data sheet is based on test results from our
laboratories as well as on experience gained in the field by our customers. It
can, however, not cover all parameters for each specific application and is
therefore not binding for us. The information given in this leaflet represents
neither a performance guarantee nor a guarantee of properties, nature,
condition, state or quality. No liability may be derived from these indications
nor from the recommendations made by our free technical advisory service.