EVA hot melt adhesive 286.30

Special cartridges for HOLZ-HER machines EVA hot melt adhesive · unfilled



For bonding edgebands for instance of HPL/CPL, polyester, resinated paper,
solid wood and veneer. The special properties of the edgebands and the
reverse primer application have to be tested before use (especially if
thermoplastic edgebands are to be bonded).

Characteristics /
Directions for Use:

Long open time, high hot tack, good adhesion and good heat resistance;
excellent resistance to oxidation as well as good colour stability in the melt.
Very good mechanical processing characteristics, accurate application
without hot melt stringing.

Processing temperature [°C]: 180 – 200

The substrate properties and the processing conditions will influence the
processes of joining and bonding. Customer trials before use are therefore

The materials to be used must be free of grease and dust and be dry, they
also have to match perfectly. Wood moisture content should be at 8 – 10 %.
Minimum temperature of substrates and ambient air should not be below
18 °C. Avoid draught.


Technical Data:
Density[g/cm3]:  approx. 1.0
Softening range [°C]: approx. 90 (Kofler bench)
Appearance: yellow translucent




Preliminary cleaning while hot by scraping with a spatula. Remove any
residues when cold with Jowat® Cleaner 402.40.


May be stored for 12 months after date of delivery ex production site, cool
and dry.

Packaging: 48 cartridges per carton, 63 mm Æ, 80 mm length, 12.2 kg net.

For further information concerning handling, transport and disposal, please
refer to the corresponding Safety Data Sheet.
Our information on this data sheet is based on test results from our
laboratories as well as on experience gained in the field by our customers. It
can, however, not cover all parameters for each specific application and is
therefore not binding for us. The information given in this leaflet represents
neither a performance guarantee nor a guarantee of properties, nature,
condition, state or quality. No liability may be derived from these indications
nor from the recommendations made by our free technical advisory service.